Wilson Electronics SignalBoost DT Dokumentacja Pobierz pdf (Strona 10)

10

Need help? www.WilsonElectronics.com Tech Support 866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

c) You need to increase the distance

between the Outside Antenna and

the Desktop Antenna by moving them

horizontally and/or vertically farther

apart making sure they are not facing

towards each other.

Increase horizontal

and/or vertical

distance

If the light is green after separating

the antennas, increase the gain

until the red light comes on. Then

slightly decrease the gain until the

green light appears. This ensures

maximum coverage.

d) If your coverage area is still too small

after separating the antennas, contact

the Wilson Electronics Technical

Support Team for assistance: 866-

294-1660.

Fixing Orange Light Issues

If any lights on the DT are orange:

a) Turn down the gain control until you

get a green light.

Wait 5 seconds

between each

adjustment

b) If the gain is not adequate for good

coverage, turn the Outside Antenna

away from the strongest cellular

signal in small increments until the

light turns green.

Turn Away

If the lights will not respond, turn the

gain down in 5 dB increments and move

the Outside Antenna. Continue to adjust

the gain and antenna positions until the

light turns green.

c) If the light remains orange, contact

the Wilson Electronics Technical

Support Team for assistance: 866-

294-1660.

Fixing Blinking Red & Orange Light

Issues

If one or more of the lights on Signal

Booster are blinking red and orange,

it indicates that the Signal Booster is

experiencing extreme receiver overload

and has shutoff.

a) Turn away Outside Antenna from

the cell tower until lights no longer

ash. If needed, contact Wilson

Electronics Technical Support Team

for assistance.

Turn Away

Fixing Blinking Red Light Issues

If one or more of the lights on Signal

Booster are blinking red, this means that

the Signal Booster has shutoff.

a) Increase the distance between

the cellular device and the Inside

Antenna.

Lights Off

If one or more of the lights on Signal

Booster are off verify power to your surge

protected power strip. If power and lights

are still off this means that the gain has

been turned all the way down and the

band is in Power Save Mode. Increase

the gain until the light turns on. If there

are bands that are not being used in

the local coverage area, this will reduce

enegy consumption.

NOTE: The DT can be reset by

disconnecting and reconnecting the power

supply.

For additional descriptions on

troubleshooting, see the install video at:

wilsonelectronics.com/DTvideo.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag