Wilson Electronics 811201 Przewodnik Instalacji Pobierz pdf (Strona 8)

Contact Wilson Electronics Tech Support with any questions at (507)282-8484

Or email: [email protected] Hours: 7am to 6pm MST.

Installing a Wilson Signal Booster

Select a location to install the Signal Booster that is away from excessive heat, direct

sunlight, moisture and that has proper ventilation. Ensure the Signal Booster is installed

within six feet of where the cellular device will be used (to accommodate the six-foot

adapter extension cable). Run the cable from the outside antenna and attach it to the

connector labeled “Outside Antenna” on the Signal Booster. Connect the power supply

(sold separately) to the power input labeled “12V DC” on the Signal Booster.

Recommended installation locations for

in-building are:

• On a wall

• On the ceiling

• Near a power outlet

In-Building

Installing a Wilson Outside Antenna – In-Building

Select a location on the roof of the building to install the outside antenna that has the most

unobstructed line of sight to the cell tower.

A Yagi antenna must be installed horizontally with the elements vertical and the drip hole

on the bottom. Ensure there are three feet of clearance in all directions surrounding the

antenna.

Follow the specic antenna installation instructions included with the outside antenna.

Lightning protection is recommended for all in-building installations. Take extreme care to

ensure neither you nor the antenna come in contact with any electrical power lines.

To obtain maximum performance, the antenna should point toward the cell tower. Follow

the instructions included with the outside antenna.

Cell Tower

RF Signal

Yagi Outside Antenna

NOTE: See RF Safety Warnings (p. 9)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Brak uwag

Wilson Electronics 811201 Przewodnik Instalacji Strona 8